Error 9 when flashing a m810lr

MikeP · Posted: Tue Jun 24, 2003 7:25 pm Post subject: Error 9 when flashing a m810lr

I need to update bios on my m810lr (62-0913-001131-00101111-071595-SYS730S-M810LR); I have worked out that it is a v7.1a and have down loaded what I believe to be the correct bios (030103s)... so far so good but alas I go to do the flash and the utility gives me an "error 9" saying old bios is M810LR and new is M810! Hummh!

Can anybody advise here, is this a querk to be ignored? :?

Many thanks.

ajzchips · Posted: Tue Jun 24, 2003 9:41 pm Post subject:

ftp://ftp.pcchips.com.tw/BIOS-n/M810L/

Try the release there. IIRC, the new BIOS releases have an auto-LAN-detect scheme, so probably the new M810 LAN and non-LAN BIOSes are identical.
_________________
<betaBIOS> <okBIOS> <Utils> <MyJob>

Denniss · Posted: Tue Jun 24, 2003 10:28 pm Post subject:

All M810 except the special verions with USB 2.0(810DLU) or with Onboard CPU (Rev 7.1c/9.0m) use the same Bios - at least with this latest release

All M810 Bios files listet on this page http://www.pcchips.com.tw/bios/bios.asp?module_id=4 link-up to the FTP-folder AJZ posted

So the bios should be correct - Pcchips seems to use only M810 with this Bios

MikeP · Posted: Thu Jun 26, 2003 10:01 am Post subject: Help! Please.

What I feared happened.

I flashed with the 030103S rom ignoring that it said M810 as opposed to M810L; the flash ran OK and the board seems to function OK but it does not recognise the LAN anymore! I have double checked the PCChips site and it definitely says 030103S for V7.1a on both the M810 and M810L boards.

Help, help please what rom should I be using to get my LAN back? :(

Much appreciate any advice here

Rainbow · Posted: Thu Jun 26, 2003 10:04 am Post subject:

Did you clear CMOS after flashing?
_________________
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere http://www.uniflash.org

MikeP · Posted: Thu Jun 26, 2003 10:20 am Post subject: Problems with M810LR

Yes, at least I assume that a full power-on from cold will do the job of clearing.

Denniss · Posted: Thu Jun 26, 2003 11:15 am Post subject:

Clear CMOS per jumper and load optimal/Performance Setting in Bios
Make sure LAN is enabled in Bios !